8085 INTERFACING WITH 8255 PDF

Home  /   8085 INTERFACING WITH 8255 PDF

Problem – Interface with microprocessor and write an assembly Subtract content of two ports by interfacing with microprocessor. The interfacing happens with the ports of the Microprocessor. The main IC’s which are to be interfaced with are: 1. PPI. 2. PIC. 3. USART. PPI: 82C55 The 82C55 is a popular interfacing component, that can interface any TTL-compatible I/O device to the microprocessor.

Author: Voodoogor Kisho
Country: Montserrat
Language: English (Spanish)
Genre: Politics
Published (Last): 23 December 2013
Pages: 408
PDF File Size: 16.99 Mb
ePub File Size: 17.91 Mb
ISBN: 796-6-43100-389-9
Downloads: 72621
Price: Free* [*Free Regsitration Required]
Uploader: Vigrel

Assume address of control word register of as 83H. Minimum Mode Configuration of Modular Programming in Microprocessor. The interfacing process involves matching the memory requirements intfrfacing the microprocessor signals.

To get absolute address, all remaining address lines A 3 — A 19 are used to decode the address for Facebook Dhanoop Bhaskar Create your badge. Interfacing 8 x 4 keyboard matrix in decoded scan keyboard mode. But to perform the operation we need an input to enter the data and an output to display the results of the operation.

In the interrupt driven mode interrupt line from is connected to the one of the interrupt input of except INTR. Initial size in write Display.

  ISO 23081-1 PDF

The lower nibble of port A of the is used to generate excitation signals in the proper sequence. Other signal connections are same as in the non interrupt mode.

Intel A Programmable Peripheral Interface

Now how to select between the two devices according to the requirement? Your email address will not be published.

Initialize in write display. Send data on port A to glow G1 and G2.

Here, 4 scan lines are sufficient to scan matrix keyboard and to select display digits. ForPort A and B are used as output ports. So there is chance of faults knterfacing defects. Get the 7 segment code. Jump back to read status. Call Delay of 0.

Load data to switch off LEDs. Initializeport A and port B.

Return to main program. Design a microprocessor system to control traffic lights.

Load control word in AL. Assume persistence of vision to be 0.

genius IT ians™: programming (part4)

Interface an 8 x 8 matrix keyboard to through in 2-key lockout mode and write an assembly language program to read keycode of the pressed key. Interface a Stepper Motor to the microprocessor system and write an assembly language program to control the Stepper Motor.

Operating Modes of So it is necessary that we interface keyboard and displays 82555 the microprocessor. Send data on PA to glow R1 and R2. S, Thrikkakkara ; St.

  AMDEC GUIDE PRATIQUE PDF

The pins are used to control relay on-off action with the help of relay driver circuits. Load control word OUT 83H: The transistors are selected such that they can source rated current for the windings. Get the Excite code.

8255A – Programmable Peripheral Interface

Motor shown in the circuit has two phases, with center-tap winding. Memory requires some signals to read from and write to registers. Check if multiplier zero, otherwise repeat. The external clock frequency is 2MHz. Find program clock command word.

The center taps of these windings are connected to the 12V supply. Send data on PB to glow G3 and G4. Thus the capability is very limited in this type of interfacing. The register values are chosen in Fig. These excitation signals are buffered using imterfacing transistors. This current is required to produce an average of 10 mA per segment as the displays are multiplexed.

A0-A7 lines are used to decode the addresses for