FIGURES, CHARTS, AND TABLES IN THE ISD SERIES DATA SHEET . ISD Series Device Pin/Pad Designations, with Respect to Die Center (µm). ISDMP Datasheet, ISD SPI Interface Record and Playback IC Datasheet, buy ISDMP Voice Record IC. ISDMP datasheet, ISDMP circuit, ISDMP data sheet: WINBOND – Single-Chip Voice Record/Playback Devices 8-, , , and.
|Published (Last):||11 September 2014|
|PDF File Size:||16.9 Mb|
|ePub File Size:||6.2 Mb|
|Price:||Free* [*Free Regsitration Required]|
This is the serial output of the ISD device All other trademarks are the property of their respective owners. Oct 31, – 4 – Revision 1.
If the Daasheet is not used, this input must be connected to ground. Memory Architecture The ISD series contains a total of 3,K Flash memory cells, which is organized as 2, rows of 1, cells each.
When a record command is sent, T  Measured with AutoMute feature disabled. Exposure to the absolute maximum ratings may affect device reliability and performance.
Oct 31, – 2 – Revision 1. Download datasheet Kb Share this page. Oct 31, Revision Copy your embed code and put on datahseet site: Oct 31, Revision 1.
This is the serial input to the ISD device when it is configured as slave. In addition, these supplies dataheet be decoupled as close to the package as possible.
Otherwise the ISD will repeat the operation from the same row address. Stresses above those listed may cause permanent damage to the device.
Care should be taken such that the data shifted in is compatible with current system operation possible to read interrupt data and start a new operation at the same time The address bits A0-A15 are used to access various rows for id4004 messages of different durations.
The duty cycle on the input clock is not critical, as the clock is immediately divided by two. Message Cueing can be selected only at the datasneet of a playback operation.
To minimize noises, the analog and digital circuits in the ISD devices use separate power busses. In this dattasheet, the messages are skipped 1, times faster than the normal playback mode. The ISD series is designed to be used in a microprocessor- or microcontroller-based system. Oct 31, – 1 – Revision 1.
Elcodis is a trademark of Elcodis Company Ltd. In addition, the device can be re- recorded typically overtimes. Refer to the AC timing table for other T to different sampling rates. Playback and record operations are initiated when the device is enabled by asserting the SS pin LOW, shifting in an opcode and an address data to the ISD device refer to the Opcode Summary in the following page.
Remove the leaded package option Remove the extended temperature option Update the external clock description Revise Ordering Information section 1. The CMOS-based devices include an on-chip oscillator, anti-aliasing iss4004, smoothing filter, AutoMute feature, audio amplifier, and high density multilevel Flash memory array.
Functional operation is not implied at these conditions.